Purchase SignTools 4 together with CorelDRAW X4 for
This is the most powerful vinyl cutting and sign making
package combination available, at a fraction of the cost of high end sign
For more information click here.
After installing CorelDRAW the next step is to install SignTools. Follow the instructions on 4 and 5 of the SignTools 4 User Guide.
Once you have installed SignTools, open Corel Draw and click on the Application Launcher (see picture below) and choose SignTools 4.
Next click on the "Cut"
button and then the "Setup" Button. Select the AIP 1120
from the "Device" drop down box
and select your port.
If you are using a Serial (Com) port click on the Properties button and set the following settings:-
Bits per second : 9600
Data bits: 8
Stop bits: 1
Flow Control: Hardware
If you are connecting your cutter via a USB connection you must install the USB driver that came with your cutter first. This will create a an extra Com and USB port that you can select in the SignTools "Device Setup" dialog box.
In CorelDraw's Layout menu select Page Setup. A dialog box
will appear. Set Width to 3200mm (126 inches) and Height to 1030mm (40 inches).
Ensure that you are using a Landscape page.
To set this as a default page in CorelDRAW click on the Tools menu and choose Options. Click on the word Document on the left hand side and ensure all of the options are ticked and click on the OK button.
To cut any object in CorelDraw, simply place on the page in the bottom left corner. If you wish to cut in a portrait fashion simply rotate your graphics.
SignTools 4 cuts from the bottom left of the page either
manually place object(s) in the bottom left of the CorelDRAW page
or use the "Vinyl Saver" tool with the sliding bar all
the way to the left.